PRODUCT DETAILS
- Combination Peel – Lactic Acid, Salicylic Acid and Resorcinol in Jessner’s (14%) and in Lite Jessner’s (7%) strength
- Non-buffered
Jessner’s solution is very effective for a wide range of patients, with particularly positive benefits for those with:
- Acne prone/oily skin
- Active acne
- Photo damage
- Fine to medium wrinkling
The Jessner’s peeling solution has been recognized for many years as a superficial to medium peeling agent. The solution is comprised for three active ingredients in an ethanol base:
- Lactic Acid is a normal metabolic product. Human skin has all the enzymes necessary to utilize it. There is no toxicity from the lactic acid. On normal skin, lactic acid is partially responsible for maintaining the acid mantle of the skin at a pH of 5.5 to 6. Several studies have shown that lactic acid has a natural moisturizing effect on the skin.
- Salicylic Acid provides powerful exfoliation due to the high lipid (oil) solubility. It concentrates exfoliation on the lipid-rich outer layers of the skin where the rate of exfoliation reduces with aging, thus causing a buildup of dull, dry skin.
- Resorcinol is a derivative of phenol. It has been used as a peeling agent for over 100 years. This component may cause a grayish appearance of the skin approximately 24 hours post-peel.
SKIN TYPES:
Normal to oily and/or acne prone skin
pH LEVELS:
Jessner’s 1.63 Lite Jessner’s 2.15
PRODUCT SIZE:
4 ounces
ACTIVE INGREDIENTS:
Lactic Acid, Salicylic Acid, and Resorcinol, U.S.P. in concentration
INACTIVE INGREDIENTS:
SD Alcohol 40B
INDICATIONS:
- Improve tone and texture
- Remove fine lines and wrinkles
- Improve hyperpigmented areas
- Correct sun damage
- Improve mild scarring
- Control oiliness and slough comedones
CONTRAINDICATIONS:
- Resorcinol reactions; severe milk and aspirin allergies.
CAUTIONS
Test spot to determine patient’s reaction to resorcinol, excessive absorption may increase risk of Salicylism (a toxic condition produced by the excessive intake of salicylic acid or salicylates and marked by ringing in the ears, nausea, and vomiting.), not to be used over 20% body’s surface area at one time.
SENSITIVE SKIN CONSIDERATIONS:
There is more risk for patients determined to have sensitive skin.
DRUG INTERACTIONS:
- Patients with severe aspirin allergies should avoid agents and products with Salicylate.
- Tretinoin or retinoic creams and/or acids will heighten the skins sensitivity to any type of peeling agent and should be left out of patients’ regimen 48-72 hours prior and post treatment.
- Most physicians recommend 12 months post-Accutane before even moderate treatments are performed.
PATIENT SELECTION:
Oily to acne prone skin types; normal skin types can have spot treatments for problem areas; desiring moderately aggressive treatment.
PRE-TREATMENT CONSIDERATIONS:
- Determine what type of treatment patient desires and that moderate peeling will not be an inconvenience at this time;
- Patient has not had a treatment in less than 7–10 days;
- Avoid broken or severely irritated skin except for those comedones still intact; refer to drug interactions.
TEST PATCHING:
More critical with this agent because of the resorcinol. Test spot near ear or on inner arm; reaction will be noted fairly quickly; therefore, test can be performed at the beginning of session.
If excessive flaring, severe burning or itching occurs do not continue with this agent. Also, Lite Jessner’s is suggested to use first, moving to Jessner’s after layers of the Lite Jessner’s treatment have been successfully tolerated.
NEUTRALIZATION:
This combination is self–neutralizing because of the salicylic, therefore frosting is almost always apparent and can be monitored more closely with a Wood’s lamp.
APPLICATION OF ACIDS:
Try to achieve one even pass by quickly making one pass and going back over the area to assure the peel is even. Effect of the acid peel cannot be stopped if unintended areas are treated or patient is uncomfortable, but 10% Sodium Bicarbonate can somewhat slow the action.
APPLICATION OF PRESSURE:
Crucial with this acid. Pressure controls the depth of peel; acid can be applied with light pressure for one pass, and if deeper peeling is desired, more pressure can be applied to area without using more acid.
Applying excessive pressure can cause deeper peeling and irritation.
LAYERING:
- Crucial with this acid. Along with pressure, layering determines the depth of peel.
- Each layer must be allowed to dry and frost; observe area before the next layer is applied.
- No more than three layers should be applied in one treatment. Secondary and tertiary layers may only be desired in specific areas.
TIMING:
Not necessary because it is self-neutralized, rinsing is not necessary.
POST TREATMENT CONSIDERATIONS:
- Follow treatment with Skin Perfect Skin Recovery Hydrator. Then apply a thin layer of a broad-spectrum sunscreen.
- Patients can expect skin sensitivity for 24-48 hours, tightening of skin for up to 72 hours, moderate flaking for 2-5 days especially in areas treated with more pressure and layers.
- Discuss the importance of maintaining the treatment results with the appropriate Skin Perfect skin care protocol as maintenance for skin.
PRE-PEEL PREPERATION:
- Record complete patient skin history.
Note: Retin-A treatments must be stopped 4-7 days prior to any acid treatment. DO NOT treat patients who have been treated with Accutane within 12 months prior.
- Discuss procedure thoroughly with patient. Patient must sign consent form prior to procedure.
- Perform patch test on patient’s upper arm.
Note: Patients with sensitivity to aspirin will likely have sensitivity to Jessner’s and Lite Jessner’s, due to the salicylic acid in the solution.
- Secure patient’s hair with headband.
- Cleanse areas to be treated with Skin Perfect Perfect Cleanser. Pat dry.
- Instruct patient to lie in a relaxed supine position, with eyes closed for the entire procedure.
- Apply 1-3 passes of ONE Peel Prep. Peel Preps remove any debris remaining on skin after cleansing, open pores and lower pH of skin to enhance effectiveness of the peel solution.
PEEL TECHNIQUE:
- Thoroughly shake solution.
- Apply acid to thickest areas of skin first.
- Apply in single strokes, in the following order:
Across forehead at hairline – moving to brow area
Down sides of face (continuing onto neck, if applicable)
Down cheeks
Across chin
Across upper lip
Down nose
- Do not allow solution to drip. Try to achieve one even pass but some overlapping is not detrimental with this acid. Patient may experience a stinging sensation. Stinging may be somewhat relieved with the use of a 6” fan.
Note: Under no circumstances should patient open eyes. If acid makes contact with eyes, flush with water for 15 minutes, occasionally lifting upper/lower lids, until no evidence of chemical remains. Continue flushing with normal saline until pH has returned to normal (30-60 minutes). Get medical attention immediately.
- Allow solution to dry. Expect to see some white frosting as the solution dries.
- Apply successive layers and allow to dry to control the depth of the peel. Each layer should dry in 2-4 minutes.
-
Total treatment time should be 7-10 minutes. Solution is self-neutralizing so it will cease working around 10 minutes after application. No addition layers should be applied after 10 minutes from the start of the treatment.
- Stinging sensation should subside with the use of a fan as the peel solution neutralizes itself.
- Apply Skin Perfect Skin Recovery Hydrator and SPF 30 Sunscreen before client leaves treatment. These products are recommended for post treatment home care: Skin Recovery Cleanser and Skin Recovery Hydrator for three days post treatment.
